Cisco CCNA 4 Simulation v6.0 Test Chapter 9
- Questions and answers - 10/1010/10
CCNA 4 Chapter 9 Quiz Questions and Answers. In this simulation, take your test, get your score and share with others!
- Points: 100
- Questions: 31
- Time limit: None
- Allowed attempts: Unlimited
Exam Chapter 8 Questions and Answers CCNA 4 V6.0
Which type of tool would an administrator use to capture packets that are going to and from a particular device?
An administrator is troubleshooting an Internet connectivity problem on a router. The output of the show interfaces gigabitethernet 0/0 command reveals higher than normal framing errors on the interface that connects to the Internet. At what layer of the OSI model is the problem likely occurring?
After which step in the network troubleshooting process would one of the layered troubleshooting methods be used?
Refer to exhibit. A network engineer is troubleshooting a WAN connectivity problem. A ping to a remote router is successful and an attempt to telnet to the same router displays the exhibited output. What does the output verify?
A network engineer issues the show cdp neighbor command on several network devices during the process of network documentation. What is the purpose of performing this command?
An internal corporate server can be accessed by internal PCs, but not by external Internet users that should have access. What could be the issue?
A team of engineers has identified a solution to a significant network problem. The proposed solution is likely to affect critical network infrastructure components. What should the team follow while implementing the solution to avoid interfering with other processes and infrastructure?
Which troubleshooting method begins by examining cable connections and wiring issues?
In which step of gathering symptoms does the network engineer determine if the problem is at the core, distribution, or access layer of the network?
A network engineer is troubleshooting a network problem and can successfully ping between two devices. However, Telnet between the same two devices does not work. Which OSI layers should the administrator investigate next?
Which two specialized troubleshooting tools can monitor the amount of traffic that passes through a switch? (Choose two.)
A company is setting up a web site with SSL technology to protect the authentication credentials required to access the web site. A network engineer needs to verify that the setup is correct and that the authentication is indeed encrypted. Which tool should be used?
A network technician is troubleshooting an email connection problem. Which question to the end-user will provide clear information to better define the problem?
Fill in the blank.
Use the __ cache to verify IPv4 address to Layer 2 Ethernet address mappings on a host computer.
A networked PC is having trouble accessing the Internet, but can print to a local printer and ping other computers in the area. Other computers on the same network are not having any issues. What is the problem?
What is a purpose of establishing a network baseline?
A user reports that after an OS patch of the networking subsystem has been applied to a workstation, it performs very slowly when connecting to network resources. A network technician tests the link with a cable analyzer and notices that the workstation sends an excessive number of frames smaller than 64 bytes and also other meaningless frames. What is the possible cause of the problem?
Users are reporting longer delays in authentication and in accessing network resources during certain time periods of the week. What kind of information should network engineers check to find out if this situation is part of a normal network behavior?
The newly configured ASBR that connects a company to the Internet has a default route configured and has the default-information originate command entered. Devices connected through this router can access the Internet. The problem is that no other OSPF routers have a default route in the routing table and no other users throughout the organization can access the Internet. What could be the problem?
Which number represents the most severe level of syslog logging?
Which statement describes the physical topology for a LAN?
Users report that the new web site http://www.company1.biz cannot be accessed. The helpdesk technician checks and verifies that the web site can be accessed with http://www.company1.biz:90. Which layer in the TCP/IP model is involved in troubleshooting this issue?
After cables were reconnected to a switch in a wiring closet, several PCs that had been previously configured manually can no longer access resources outside the local network. The PC configurations were not altered in the process and resources on the local network can still be accessed. What is a possible cause of the problem?
A network administrator is configuring SSH on a router. When verifying the configuration, the administrator notices that the SSH connection requests fail, but the Telnet connection requests from the same workstation are successful. Which two parts of the router configuration should be checked to try to locate the problem? (Choose two.)
A user reports that the workstation cannot connect to a networked printer in the office in order to print a report created with word processing software. Which troubleshooting action by the helpdesk technician would follow the divide-and-conquer approach?
A user in a large office calls technical support to complain that a PC has suddenly lost connectivity to the network. The technician asks the caller to talk to nearby users to see if other machines are affected. The caller reports that several immediate neighbors in the same department have a similar problem and that they cannot ping each other. Those who are seated in other departments have connectivity. What should the technician check as the first step in troubleshooting the issue?
Refer to the exhibit. Which two statements describe the results of entering these commands? (Choose two.)
Match the troubleshooting tool to the correct category. (Not all options are used.)
A group of Windows PCs in a new subnet has been added to an Ethernet network. When testing the connectivity, a technician finds that these PCs can access local network resources but not the Internet resources. To troubleshoot the problem, the technician wants to initially confirm the IP address and DNS configurations on the PCs, and also verify connectivity to the local router. Which three Windows CLI commands and utilities will provide the necessary information? (Choose three.)
When should a network performance baseline be measured?